Products

Decorative and Finishing Products

S-2630E

 

S-2630 E is a two part water-borne epoxy paint available in a range of colours.  It cures to a matt film.

 

APPLICATIONS
S-2630 E may be used to change the colour of bricks or their texture if sand is incorporated.


INSTRUCTIONS
Reference to the Material Safety Data Sheet before use.  Mix both Part 1 and Part 2 thoroughly before mixing together.Ensure that the surface is clean, it may, of course be wet.  If a dry porous surface is to be coated then slightly damp it with water spray before applying the paint.

Mix the components in the ratio Part 1: Part 2 = 1:5 by weight.  If required grit or sand may be added at this point or sprinkled on the surface, possibly with another coat on top, depending on the effect it is desired to create.

S-2688E

 

 

DESCRIPTION
S-2688E is a two-part cold curing epoxy sealant. 

INSTRUCTIONS
References should be made to Material Safety Data Sheet.  The surfaces should be dust free but need not be dry.  Any metal reinforcement should be free of loose corrosion.  Mix part 1 with part 2 in the ratio stated below and stir thoroughly to ensure complete mixing of both parts.  Apply the sealant to the prepared surface with a brush or serrated trowel to give a thickness of approximately 1 to 1.5 mm.  Leave to cure for 8 hours.

S-2283E

 

 

DESCRIPTION
S - 2283 E is a clear two part, cold curing epoxy lacquer.  S - 2283 E is designed to repair cracks and coat faces of sand-faced bricks.

APPLICATIONS
S - 2283 E may be used either
1)    to coat bricks to receive a sprinkled coating of sand to achieve special effects or
2)    to repair cracks in building products.


INSTRUCTIONS
Reference should be made to the Material Safety Data Sheet.  S - 2283 E is mixed in the ratio of Part 1:Part 2 = 2:1 by weight or volume.  Do not mix more than can be used within the pot-life of the adhesive.  The mixed material is applied to the bricks by spotting from a syringe in case of cracks and by paint brush in making sanded faces.

NOTE.  When used as a lacquer to receive sand, paint a thin coat onto the brick surface as the sand will sink, and disappear, into a thick coat.  As the cure of the mix to be painted proceeds its viscosity will increase, whilst still being paintable.  This increases the risk of applying too thick a coat

S-2425E

 

 

DESCRIPTION
S - 2425 E is a two part, cold curing epoxy paint.  It is easy to mix being made of two weak pastes.  It is easy to paint with as it does not drag, it is also non-drip.

APPLICATIONS
S - 2425 E may be used on clayware pipes as a sealer coat.


INSTRUCTIONS
Reference should be made to the Material Safety Data before use.
Ensure that the surface to be painted is clean, dry and free from dust.  Mix the paint thoroughly in the ratio Part 1 : Part 2 = 3:1 by weight.  Do not mix more that can be painted within the work-life.  Allow the paint to cure before moving the pipe.

S-693E

 

 

  • S-693A may be used to bond glass to itself, for example, glass bevels to windows.
  • S-693A permits the assembly of several bevels since it offers sufficient delay in the cure to allow the whole design to be put in position.
  • S-693A is a clear, single part adhesive designed to bond glass and to cure under ultra-violet irradiation.