S-2665E
S-2665E is a two-part, cold curing epoxy adhesive. It is designed to bond brick slips to various substrates such as concrete, ply wood, exposed aggregate, stainless steel and aluminium. It is designed for dispensing from a 400ml 1:1 ratio twin cartridge by an air–powered gun through a 10mm static mixer with 10 elements and a exit hole diameter of 5mm. This gives an 8mm-diameter bead. It is a rapid cure adhesive that cures in 4 hours.
INSTRUCTIONS
Refer to the Material Safety Data Sheet before use. Fit the twin cartridge into the dispensing gun, fit a static mixer into the retaining nut, and screw that on the cartridge. Output can be increased by cutting one or more “shoulders” off the nozzle and by increasing the air pressure.
Apply two beads of adhesive about 2-3cms apart horizontally along the surface to be covered. These beads will be approximately 1cms from the top and the bottom of the brick slips when applied. Carry these beads along the surface to the edge. Apply the Brick slips along the line of the beads and press firmly into the adhesive, use spacers of required width to provide an appropriate spacing of the slips. Carry on in the manner to the end of the row. Apply two more beads to form the basis for the next row and carry on until the surface is covered. It wets out well on damp and dry bricks. If the mix is left in the static mixer for longer than its work- life, it will set solid so requiring a new static mixer, one should discharge the whole contents of the cartridge quickly. By this means a mixer could be re-used on a second cartridge
NOTE: This adhesive has a four-hour cure time and this should be taken into account when applying the brick slips. Do not apply more rows than can be held in place by the uncured adhesive.
RSS Feed
